Hey folks,
I noticed some of the trim around this door is bending. I assume it is likely due to humidity but any other possible causes? This is in the basement where it is typically cool.
What do you recommend I do to fix it? Just some simple wood glue and something to hold it in place as the glue dries?
Yes it’s caused by moisture. If you push it in manually does it go right back in place? If so yes glue and nails to hold it while it cures. If it doesn’t then you will need to start at the bottom and pull the piece of trim up until you get to the bubble and then refasten it from that point down to take up the slack.
Yeah it goes back in place and fits perfectly once i push it back into place. I’ll go the glue and nail route. Thanks!
I’d suggest looking into getting a dehumidifier as well. That’s a lot of moisture.