Why are you having to update your DNS records when you add a new service? Just set up a wildcard A record to send *.myserver.com to the reverse proxy and you never have to touch it again. If your DNS doesn’t let you set wildcard A records, then switch to a better DNS.
That wasy exact setup as well until I switched to a different router which supported both custom DNS entries and blocklists, thereby making the pi-hole redundant
I switched to Technitium and I’ve been pretty happy. Seems very robust, and as a bonus was easy to use it to stop DNS leaks (each upstream has a static route through a different Mullvad VPN, and since they’re queried in parallel, a VPN connection can go down without losing any DNS…maybe this is how pihole would have handled it too though).
Why are you having to update your DNS records when you add a new service? Just set up a wildcard A record to send *.myserver.com to the reverse proxy and you never have to touch it again. If your DNS doesn’t let you set wildcard A records, then switch to a better DNS.
Not OP but a lot of people probably use pi-hole which doesn’t support wildcards for some inane reason
That’s my case. I send every new subdomain to my nginx IP on pi-hole and then use nginx as a reverse proxy
That wasy exact setup as well until I switched to a different router which supported both custom DNS entries and blocklists, thereby making the pi-hole redundant
I run opnsense, so I need to dump pi-hole. But I don’t have the energy right now to do that.
Pi-Hole was pretty straightforward at the time and I did not look back since then. Annoying, but easy.
I switched to Technitium and I’ve been pretty happy. Seems very robust, and as a bonus was easy to use it to stop DNS leaks (each upstream has a static route through a different Mullvad VPN, and since they’re queried in parallel, a VPN connection can go down without losing any DNS…maybe this is how pihole would have handled it too though).
And of course, wildcards supported no problem.